Use the Fiskars wire winder to create this card with a difference.
Project
Shopping List
Fiskars wire winder
Peg template 3
Pattern template 8-3
3 x black craf pipe cleaners
2 x white craft pipe cleaners
scissors
A4 black card
A5 gold textured paper
A5 smooth gold card
Hot glue gun or good all purpose glue
rule
double sided sticky tape
Instructions
Step one - Select the peg template 8 and the pattern 8-3 and set up the wire winder.
Step two - Take one of the pipe cleaners and gently bend in half. Place by the largest peg.
Step three - Wind one half of the pipe cleaner around the large round pegs.
Step four - Wind the other side around the pegs.
Step five - When you get to the end twist the ends around one another a coupdl of times to secure.
Step six - When the pipe cleaner wraps over itself twist around twice to ensure the cleaner holds its shape.
Step seven - Cut off any excess wire.
Step eight - Create another two of these in black so you make three in total.
Step nine - Repeat this process to make two white twisted shapes.
Step ten - Fold the A4 card in half. Using the rule to create straight lines tear the textured paper so it is slightly smaller than the folded A4 card. Then repedat the process with the smooth gold card.
Step eleven - Layer these onto the front of the card centrally.
Step twelve - Using the hot glue gut attach the twisted pipe cleaners starting with the black in the design shown in our main picture.
Tricks of the Trade
There are currently no tricks of the trade associated with this project
