This fun little project uses a great tool by Fiskars which helps you twist/bend wire easily each and every time.
Instructions
Step one - Take a red pipe cleaner and begin to wind it around the pegs.
Step two - When you have worked all the way around the pegs slip the end of the pipe cleaner under the shape.
Step three - Now take the yellow pipe cleaner and slip it through the design, through the middle to the back.
Step four - Now wind the pipe cleaner around the inner pegs and when you have worked all the way around slip the end down the middle to the back. Now gently pull off of the pegs, holding in place to ensure they do not come apart.
Step five - Pull the end of the red pipe cleaner through the middle then back down.
Step six - Do not pull the pipe cleaner all the way back through but allow it to create a little loop this will make the centre of your flower.
Step seven - Turn the flower over and twist the ends of the wires around one another and cut off any unwanted wire. Make another two flowers in just the same way.
Step eight - Cut the yellow ribbled card 5cm by 5cm (2" x 2") cut the A5 red card 6cm x 6cm (2 1/4" x 2 1/4") then the A5 yellow card 7cm x 7cm (2 3/4" x 2 3/4"). Fold the A4 red card in half with the two short ends meeting.
Step nine - Layer the squares of card to cretae three squares.
Step ten - Attach these three layers squares onto the folded red card.
Step eleven - To complete attach the flowers to the squares using the hot glue gun.
Tricks of the Trade
There are currently no tricks of the trade associated with this project
