|
|
Project Shopping List
Plain wooden frame
Polymer clay
Rolling pin with tracing paper or pasta mmachine
Texture mat
Lustre powder
Fine brush
Tissue paper
Craft knife
Varnish
|
 |
| All Dads love to have photos of the kids. And if they just love their music then this frame is just the ticket. |
Instructions |
|
Step one - Knead the polymer clay well then roll out to around 2mm (1/8") thick. Place the frame onto the polymer caly and cut out the aperture leaving enough to wrap around inside of aperture.
|
|
Step two - Press the texture mat into the surface of the polymer clay using the roling pin if needed.
|
|
Step three - Place the wooden frame onto the back of the polymer clay and begin to fold the caly around the frame.
|
|
Step four - When this has been done around all four sides and inside the aperture, turn over and lightly dust with the lustre powder.
|
|
Step five - Rub with the tissue to remove lustre powder from the surface but leave in the indents. Bake as per manufacturers instructions. Finally one cool varnish and mount dad favourite picture.
|
Tricks of the Trade
There are currently no tricks of the trade associated with this project
|
Printer Friendly Page |
