|
|
Project Shopping List
Trinket box
Pink bugle and seed beads
Flourist wire
5 small paper flowers
5mm white ribbon
Pearl pink 3d fabric paint
Pink acrylic paint
Thin nose pliers.
Glue and glue gun
|
 |
| Covered in roses and beads this little box is sure to delight. |
Instructions |
|
step one - Paint the trinket box with 2 coats of acrylic paint and allow to dry. On the base, glue white ribbon around the circumference then using 3-D pearl pink fabric paint, paint little dots eithr side of the ribbon. Place to one side to allow to dry
|
|
step two - Cut four lengths of florist wire then create a tiny loop at one end of the wire with your pliers. Feed on the beads- one bugle, three seed, one bugle, 3 seed and so on until you have 5 bugles and 12 seed beads for each bead loop. Then feed the tail of the wire through the little loop. Repeat this so you have 4 loops.
|
|
step three - Glue the 4 stems of the bead loops, into a cross shape. Cut stems of flowers leaving 5mm of wire on flower head. Push the 5 mm of wire to one side as tucking it under the petals (to secure flower head). Glue 4 of the paper flowers in a square shape, with their heads slightly on one side and the flowers sit in between each bead loop. Leave a small gap in the centre for the 5th paper flower to sit snug. Glue the 5th flower so it sits slightly raised compared to the other flowers. Paint little dots along the top edge of the lid with the 3d pearl pink fabric paint. Allow to dry
|
Tricks of the Trade
There are currently no tricks of the trade associated with this project
|
Printer Friendly Page |
